Rainbow Electronics GM862-QUAD-PY - Manual (Page 170)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 170 of 434
+CSMS - Select Message Service SELINT 2
AT+CSMS=
<service> Set command selects messaging service <service>. It returns the types of
messages supported by the ME:
Parameter:
<service>
0 - The syntax of SMS AT commands is compatible with GSM 07.05
Phase 2 version 4.7.0 (factory default)
Set command returns the types of messages supported by the ME:
+CSMS: <mt>,<mo>,<bm>
where:
<mt> - mobile terminated messages support
0 - type not supported
1 - type supported
<mo> - mobile originated messages support
0 - type not supported
1 - type supported
<bm> - broadcast type messages support
0 - type not supported
1 - type supported
AT+CSMS? Read command reports current service setting along with supported
message types in the format:
+CSMS: <service>,<mt>,<mo>,<bm>
where:
<service> - messaging service (see above)
<mt> - mobile terminated messages support (see above)
<mo> - mobile originated messages support (see above)
<bm> - broadcast type messages support (see above)
AT+CSMS=? Test command reports the supported value of the parameter <service>.
Reference GSM 07.05; GSM 03.40; GSM 03.41
3.5.5.1.2 Preferred Message Storage - +CPMS
+CPMS - Preferred Message Storage SELINT 0 / 1
AT+CPMS[=
<memr>
[,<memw>
[,<mems>]]] Set command selects memory storages <memr>, <memw> and <mems>
to be used for reading, writing, sending and storing SMs.
Parameters:
<memr> - memory from which messages are read and deleted
"SM" - SIM SMS memory storage
"ME" - ME internal storage (read only, no delete)
<memw> - memory to which writing and sending operations are made
"SM" - SIM SMS memory storage