Rainbow Electronics GM862-QUAD-PY - Manual (Page 190)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 190 of 434
+CNMI - New Message Indications To Terminal Equipment SELINT 2
E
=
0
#
S
M
S
M
O
D
E
=
0
#
S
M
S
M
O
D
E
=
0
#
S
M
S
M
O
D
E
=
0
#
S
number (e.g. octet 0x2A will be converted as two
characters 0x32 0x41)
Class 2 messages and messages in the “store” message waiting
indication group result in indication as defined in <mt>=1.
3 - Class 3 SMS-DELIVERs are routed directly to TE using
unsolicited result codes defined in <mt>=2. Messages of other
data coding schemes result in indication as defined in <mt>=1.
<bm> - broadcast reporting option
0 - Cell Broadcast Messages are not sent to the DTE
2 - New Cell Broadcast Messages are sent to the DTE with the
unsolicited result code:
(PDU Mode)
+CBM: <length><CR><LF><PDU>
where:
<length> - PDU length
<PDU> - message PDU
(TEXT Mode)
+CBM:<sn>,<mid>,<dcs>,<pag>,<pags><CR><LF><data>
where:
<sn> - message serial number
<mid> - message ID
<dcs> - Data Coding Scheme
<pag> - page number
<pags> - total number of pages of the message
<data> - CBM Content of Message
• If <dcs> indicates that GSM03.38 default alphabet is used ,
each character of GSM alphabet will be converted into
current TE character set (see +CSCS)
• If <dcs> indicates that 8-bit or UCS2 data coding scheme is
used, each 8-bit octet will be converted into two IRA
character long hexadecimal number (e.g. octet 0x2A will be
converted as two characters 0x32 0x41)
<ds> - SMS-STATUS-REPORTs reporting option
0 - status report receiving is not reported to the DTE
1 - the status report is sent to the DTE with the following unsolicited
result code:
(PDU Mode)
+CDS: <length><CR><LF><PDU>
where:
<length> - PDU length
<PDU> - message PDU