Rainbow Electronics GM862-QUAD-PY - Manual (Page 87)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 87 of 434
+COPS - Operator Selection SELINT 0 / 1
1 - available
2 - current
3 - forbidden
Note: since with this command a network scan is done, this command may
require some seconds before the output is given.
Reference GSM 07.07
3.5.4.3.5 Facility Lock/Unlock - +CLCK
+CLCK - Facility Lock/Unlock SELINT 0 / 1
AT+CLCK=
<fac>,<mode>
[,<passwd>
[,<class>]] Execution command is used to lock or unlock a ME o a network facility.
Parameters:
<fac> - facility
"SC" - SIM (PIN request) (device asks SIM password at power-up and
when this lock command issued)
"AO"- BAOC (Barr All Outgoing Calls)
"OI" - BOIC (Barr Outgoing International Calls)
"OX" - BOIC-exHC (Barr Outgoing International Calls except to Home
Country)
"AI" - BAIC (Barr All Incoming Calls)
"IR" - BIC-Roam (Barr Incoming Calls when Roaming outside the home
country)
"AB" - All Barring services (applicable only for <mode>=0)
"AG" - All outGoing barring services (applicable only for <mode>=0)
"AC" - All inComing barring services (applicable only for <mode>=0)
"FD" - SIM fixed dialling memory feature (if PIN2 authentication has not
been done during the current session, PIN2 is required as
<passwd>)
"PN" - network Personalisation
"PU" - network subset Personalisation
<mode> - defines the operation to be done on the facility
0 - unlock facility
1 - lock facility
2 - query status
<passwd> - shall be the same as password specified for the facility from
the DTE user interface or with command Change Password
+CPWD
<class> - sum of integers each representing a class of information (default
is 7)
1- voice (telephony)
2 - data (refers to all bearer services)
4 - fax (facsimile services)