Rainbow Electronics GM862-QUAD-PY - Manual (Page 288)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 288 of 434
#MBN - Mailbox Numbers SELINT 2
lines will be returned.
AT#MBN=? Test command returns the OK result code.
3.5.7.1.53 Message Waiting Indication - #MWI
#MWI - Message Waiting Indication SELINT 2
AT#MWI=<enable> Set command enables/disables the presentation of the message waiting
indicator URC.
Parameter:
<enable>
0 - disable the presentation of the #MWI URC
1 - enable the presentation of the #MWI URC each time a new message
waiting indicator is received from the network and, at startup, the
presentation of the status of the message waiting indicators, as they
are currently stored on SIM..
The URC format is:
#MWI: <status>,<indicator>[,<count>]
where:
<status>
0 - clear: it has been deleted one of the messages related to the indicator
<indicator>.
1 - set: there’s a new waiting message related to the indicator <indicator>
<indicator>
1 - either Line 1 (CPHS context) or Voice (3GPP context)
2 - Line 2 (CPHS context only)
3 - Fax
4 - E-mail
5 - Other
<count> - message counter: network information reporting the number of
pending messages related to the message waiting indicator
<indicator>.
The presentation at startup of the message waiting indicators status, as
they are currently stored on SIM, is as follows:
#MWI: <status>[,<indicator>[,<count>][<CR><LF>
#MWI: <status>,<indicator>[,<count>][...]]]
where:
<status>
0 - no waiting message indicator is currently set: if this the case no other
information is reported