Rainbow Electronics GM862-QUAD-PY - Manual (Page 328)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 328 of 434
#FTPPUT - FTP Put SELINT 0 / 1
Note: use the escape sequence +++ to close the data connection.
Note: The command causes an ERROR result code to be returned if no
FTP connection has been opened yet.
#FTPPUT - FTP Put
SELINT 2
AT#FTPPUT=
[<filename>] Execution command, issued during an FTP connection, opens a data
connection and starts sending <filename> file to the FTP server.
If the data connection succeeds, a CONNECT indication is sent, otherwise
a NO CARRIER indication is sent.
Parameter:
<filename> - string type, name of the file.
Note: use the escape sequence +++ to close the data connection.
Note: The command causes an ERROR result code to be returned if no
FTP connection has been opened yet.
AT#FTPPUT=? Test command returns the OK result code.
3.5.7.4.5 FTP Get - #FTPGET
#FTPGET - FTP Get SELINT 0 / 1
AT#FTPGET=
<filename> Execution command, issued during an FTP connection, opens a data
connection and starts getting a file from the FTP server.
If the data connection succeeds a CONNECT indication is sent, otherwise a
NO CARRIER indication is sent.
The file is received on the serial port.
Parameter:
<filename> - file name, string type.
Note: The command causes an ERROR result code to be returned in case
no FTP connection has been opened yet.
Note: Command closure should always be handled by application. In order
to avoid download stall situations a timeout should be implemented by the
application.
#FTPGET - FTP Get
SELINT 2
AT#FTPGET=
[<filename>] Execution command, issued during an FTP connection, opens a data
connection and starts getting a file from the FTP server.
If the data connection succeeds a CONNECT indication is sent, otherwise a
NO CARRIER indication is sent.