Rainbow Electronics GM862-QUAD-PY - Manual (Page 124)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 124 of 434
+CMER - Mobile Equipment Event Reporting SELINT 2
(after +++ was entered), all URCs stored in the buffer will be output.
<keyp> - keypad event reporting
0 - no keypad event reporting
<disp> - display event reporting
0 - no display event reporting
<ind> - indicator event reporting
0 - no indicator event reporting
2 - indicator event reporting
<bfr> - TA buffer clearing
0 - TA buffer of unsolicited result codes is cleared when <mode> 1..3 is
entered
AT+CMER? Read command returns the current setting of parameters, in the format:
+CMER: <mode>,<keyp>,<disp>,<ind>,<bfr>
AT+CMER=? Test command returns the range of supported values for parameters
<mode>, <keyp>, <disp>, <ind>, <bfr>, in the format:
+CMER: (list of supported <mode>s),(list of supported <keyp>s),
(list of supported <disp>s),(list of supported <ind>s),(list of supported
<bfr>s)
Reference GSM 07.07
3.5.4.4.7 Select Phonebook Memory Storage - +CPBS
+CPBS - Select Phonebook Memory Storage SELINT 0 / 1
AT+CPBS[=
<storage>] Set command selects phonebook memory storage <storage>, which will be
used by other phonebook commands.
Parameter:
<storage>
"SM" - SIM phonebook
"FD" - SIM fixed dialling-phonebook (only phase 2/2+ SIM)
"LD" - SIM last-dialling-phonebook (+CPBF is not applicable for this
storage)
"MC" - device missed (unanswered received) calls list (+CPBF is not
applicable for this storage)
"RC" - ME received calls list (+CPBF is not applicable for this storage)
Note: If parameter is omitted then Set command has the same behaviour as
Read command.
AT+CPBS? Read command returns the actual values of the parameter <storage>, the
number of occupied records <used> and the maximum index number
<total>, in the format:
+CPBS: <storage>,<used>,<total>
Note: For <storage>=”MC”: if there are more than one missed calls from