Rainbow Electronics GM862-QUAD-PY - Manual (Page 152)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 152 of 434
+CGATT - GPRS Attach Or Detach SELINT 0 / 1
Example AT+CGATT?
+CGATT: 0
OK
AT+CGATT=?
+CGATT: (0,1)
OK
AT+CGATT=1
OK
Reference GSM 07.07
3.5.4.7.3 GPRS Event Reporting - +CGEREP
+CGEREP - GPRS Event Reporting SELINT 2
AT+CGEREP=
[<mode>[,<bfr>]] Set command enables or disables sending of unsolicited result codes
+CGEV: XXX (see below) from TA to TE in the case of certain events
occurring in the TA or the network.
Parameters:
<mode> - controls the processing of URCs specified with this command
0 - Buffer unsolicited result codes in the TA. If TA result code buffer is full,
the oldest one can be discarded. No codes are forwarded to the TE.
1 - Discard unsolicited result codes when TA-TE link is reserved (e.g. in
on-line data mode); otherwise forward them directly to the TE.
2 - Buffer unsolicited result codes in the TA when TA-TE link is reserved
(e.g. in on-line data mode) and flush them to the TE when TA-TE link
becomes available; otherwise forward them directly to the TE.
<bfr> - controls the effect on buffered codes when <mode> 1 or 2 is
entered:
0 - TA buffer of unsolicited result codes defined within this command is
cleared when <mode>=1 or 2 is entered.
1 - TA buffer of unsolicited result codes defined within this command is
flushed to the TE when <mode>=1 or 2 is entered (OK response shall
be given before flushing the codes)
Unsolicited Result Codes
The following unsolicited result codes and the corresponding events are
defined:
+CGEV: REJECT <PDP_type>, <PDP_addr>
A network request for PDP context activation occurred when the TA
was unable to report it to the TE with a +CRING unsolicited result code
and was automatically rejected
+CGEV: NW REACT <PDP_type>, <PDP_addr>, [<cid>]
The network has requested a context reactivation. The <cid> that was