Rainbow Electronics GM862-QUAD-PY - Manual (Page 392)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 392 of 434
#CSURVF - Network Survey Format
SELINT 2
AT#CSURVF=
[<format>] Set command controls the format of the numbers output by all the Easy
Scan®
Parameter:
<format> - numbers format
0 - Decimal
1 - Hexadecimal values, no text
2 - Hexadecimal values with text
AT#CSURVF? Read command reports the current number format, as follows:
#CSURVF: <format>
AT#CSURVF=? Test command reports the supported range of values for the parameter
<format>.
3.5.7.7.8 <CR><LF> Removing On Easy Scan® Commands Family -
#CSURVNLF
#CSURVNLF - <CR><LF> Removing On Easy Scan® Commands Family SELINT 0 / 1
AT#CSURVNLF
[=<value>] Set command enables/disables the automatic <CR><LF> removing from
each information text line.
Parameter:
<value>
0 - disables <CR><LF> removing; they’ll be present in the information text
(factory default)
1 - remove <CR><LF> from imformation text
Note: if parameter is omitted the behaviour of Set command is the same as
Read command.
AT#CSURVNLF? Read command reports whether automatic <CR><LF> removing is currently
enabled or not, in the format:
<value>
AT#CSURVNLF=? Test command reports the range of values for parameter <value>.
#CSURVNLF - <CR><LF> Removing On Easy Scan® Commands Family
SELINT 2
AT#CSURVNLF=
[<value>] Set command enables/disables the automatic <CR><LF> removing from
each information text line.
Parameter:
<value>
0 - disables <CR><LF> removing; they’ll be present in the information text
(factory default)
1 - remove <CR><LF> from imformation text