46 query sim status - #qss – Rainbow Electronics GM862-QUAD-PY User Manual
Page 280
AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 280 of 434
#COPSMODE - +COPS Mode
SELINT 0 / 1
1 - +COPS behaviour compliant with ETSI format
Note: The setting is saved in NVM (and available on following reboot).
Note: if parameter <mode> is omitted the behaviour of Set command is
the same as Read command.
AT#COPSMODE?
Read command returns the current behaviour of +COPS command, in the
format:
#COPSMODE: <mode>
where
<mode> - +COPS behaviour as seen before.
AT#COPSMODE=?
Test command returns the range of available values for parameter
<mode>.
Note
It’s suggested to reboot the module after every #COPSMODE setting.
3.5.7.1.46 Query SIM Status - #QSS
#QSS - Query SIM Status
SELINT 0 / 1
AT#QSS[=
[<mode>]]
Set command enables/disables the Query SIM Status unsolicited indication
in the ME.
Parameter:
<mode> - type of notification
0 - disabled (factory default); it’s possible only to query the current SIM
status through Read command AT#QSS?
1 - enabled; the ME informs at every SIM status change through the
following unsolicited indication:
#QSS: <status>
where:
<status> - current SIM status
0 - SIM NOT INSERTED
1 - SIM INSERTED
Note: issuing AT#QSS<CR> is the same as issuing the Read command.
AT#QSS?
Read command reports whether the unsolicited indication #QSS is currently
enabled or not, along with the SIM status, in the format:
#QSS: <mode>,<status>
(<mode> and <status> are described above)
AT#QSS=?
Test command returns the supported range of values for parameter
<mode>.