Rainbow Electronics GM862-QUAD-PY - Manual (Page 39)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 39 of 434
&V3 - Extended S Registers Display SELINT 0 / 1 / 2
<reg1> <dec> <hex>
...
where
<regn> - S register number
000..005
007
012
025
030
038
<dec> - current value in decimal notation
<hex> - current value in hexadecimal notation
3.5.3.1.18 Display Last Connection Statistics - &V2
&V2 - Display Last Connection Statistics SELINT 0 / 1 / 2
AT&V2 Execution command returns the last connection statistics & connection
failure reason.
3.5.3.1.19 Single Line Connect Message - \V
\V - Single Line Connect Message SELINT 0 / 1 / 2
AT\V<n> Execution command set single line connect message.
Parameter:
<n>
0 - off
1 - on
3.5.3.1.20 Country Of Installation - +GCI
+GCI - Country Of Installation SELINT 0 / 1 / 2
AT+GCI=<code> Set command selects the installation country code according to
ITU-T.35 Annex A.
Parameter:
<code>
59 - it currently supports only the Italy country code
AT+GCI? Read command reports the currently selected country code.
AT+GCI=? Test command reports the supported country codes.
Reference V25ter.
3.5.3.1.21 Line Signal Level - %L
%L - Line Signal Level SELINT 0 / 1 / 2