Rainbow Electronics GM862-QUAD-PY - Manual (Page 165)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 165 of 434
+CGPADDR - Show PDP Address SELINT 2
AT+CGPADDR=?
+CGPADDR: (1)
OK
Reference GSM 07.07
3.5.4.7.10 Enter Data State - +CGDATA
+CGDATA - Enter Data State SELINT 0 / 1
AT+CGDATA=
[<L2P>,[<cid>
[,<cid>[,…]]]] Execution command causes to perform whatever actions are necessary to
establish a communication with the network using one or more GPRS PDP
types.
Parameters:
<L2P> - string parameter that indicates the layer 2 protocol to be used
"PPP" - PPP Point-to-point protocol
<cid> - numeric parameter which specifies a particular PDP context
definition (see +CGDCONT command).
Note: if parameter <L2P> is omitted, the layer 2 protocol is unspecified
AT+CGDATA=? Test command reports information on the supported layer 2 protocols.
Note: the representation format of the Test command output is not included
in parenthesis
Example AT+CGDATA=?
+CGDATA: ”PPP”
OK
AT+CGDATA=”PPP”,1
OK
Reference GSM 07.07
+CGDATA - Enter Data State
SELINT 2
AT+CGDATA=
[<L2P>,[<cid>
[,<cid>[,…]]]] Execution command causes to perform whatever actions are necessary to
establish a communication with the network using one or more GPRS PDP
types.
Parameters:
<L2P> - string parameter that indicates the layer 2 protocol to be used
"PPP" - PPP Point-to-point protocol
<cid> - numeric parameter which specifies a particular PDP context
definition (see +CGDCONT command).
Note: if parameter <L2P> is omitted, the layer 2 protocol is unspecified
AT+CGDATA=? Test command reports information on the supported layer 2 protocols.