Rainbow Electronics GM862-QUAD-PY - Manual (Page 378)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 378 of 434
#CSURV - Network Survey SELINT 0 / 1
AT#CSURV?
AT*CSURV? Read command has the same behaviour as Execution command with
parameters omitted.
Example AT#CSURV
Network survey started…
arfcn: 48 bsic: 24 rxLev: -52 ber: 0.00 mcc: 610 mnc: 1
lac: 33281 cellId: 3648 cellStatus: CELL_SUITABLE
numArfcn: 2 arfcn: 30 48 numChannels: 5 array: 14 19 22
48 82
arfcn: 14 rxLev: 8
Network survey ended
OK
Note The command is executed within max. 2 minutes.
#CSURV - Network Survey
SELINT 2
AT#CSURV[=
[<s>,<e>]]
AT*CSURV[=
[<s>,<e>]]
(both syntax are
possible; the second
syntax is maintained
only for backward
compatibility and will
not be present in
future versions) Execution command allows to perform a quick survey through channels
belonging to the band selected by last #BND command issue, starting from
channel <s> to channel <e>. Issuing AT#CSURV<CR>, a full band scan is
performed.
Parameters:
<s> - starting channel
<e> - ending channel
After issuing the command the device responds with the string:
Network survey started…
and, after a while, a list of informations, one for each received carrier, is
reported, each of them in the format:
(For BCCH-Carrier)
arfcn: <arfcn> bsic: <bsic> rxLev: <rxLev> ber: <ber> mcc: <mcc>
mnc: <mnc> lac: <lac> cellId: <cellId> cellStatus: <cellStatus>
numArfcn: <numArfcn> arfcn: [<arfcn1> ..[ <arfcn64>]]
[numChannels: <numChannels> array: [<ba1> ..[<ba32>]] [pbcch:
<pbcch> [nom: <nom> rac: <rac> spgc: <spgc> pat: <pat> nco: <nco>
t3168: <t3168> t3192: <t3192> drxmax: <drxmax> ctrlAck: <ctrlAck>
bsCVmax: <bsCVmax> alpha: <alpha> pcMeasCh: <pcMeasCh>]]]