Rainbow Electronics GM862-QUAD-PY - Manual (Page 332)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 332 of 434
#FTPLIST - FTP List SELINT 0 / 1
AT#FTPLIST[=
<name>] Execution command, issued during an FTP connection, opens a data
connection and starts getting from the server the list of contents of the
specified directory or the properties of the specified file.
Parameter:
<name> - string type, it’s the name of the directory or file.
Note: The command causes an ERROR result code to be returned if no
FTP connection has been opened yet.
Note: issuing AT#FTPLIST<CR> opens a data connection and starts
getting from the server the list of contents of the working directory.
#FTPLIST - FTP List
SELINT 2
AT#FTPLIST[=
[<name>]] Execution command, issued during an FTP connection, opens a data
connection and starts getting from the server the list of contents of the
specified directory or the properties of the specified file.
Parameter:
<name> - string type, it’s the name of the directory or file.
Note: The command causes an ERROR result code to be returned if no
FTP connection has been opened yet.
Note: issuing AT#FTPLIST<CR> opens a data connection and starts
getting from the server the list of contents of the working directory.
AT#FTPLIST=? Test command returns the OK result code.
3.5.7.5 Enhanced Easy GPRS® Extension AT Commands
3.5.7.5.1 Authentication User ID - #USERID
#USERID - Authentication User ID SELINT 0 / 1
AT#USERID
[=<user>] Set command sets the user identification string to be used during the
authentication step.
Parameter:
<user> - string type, it’s the authentication User Id; the max length for this
value is the output of Test command, AT#USERID=? (factory
default is the empty string “”).
Note: If parameter is omitted then the behaviour of Set command is the
same of Read command.
AT#USERID? Read command reports the current user identification string, in the format: