Rainbow Electronics GM862-QUAD-PY - Manual (Page 275)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 275 of 434
#MONI - Cell Monitor SELINT 0 / 1
An enhanced version of the Test command has been defined:
AT#MONI=??
AT#MONI=?? Enhanced test command reports the maximum number of cells, in a
neighbour of the serving cell and including it, from which we can extract
GSM-related informations, along with the ordinal number of the current
selected cell, in the format:
#MONI: (<MaxCellNo>,<CellSet>)
where:
<MaxCellNo> - maximum number of cells, in a neighbour of the serving cell
and including it, from which we can extract GSM-related informations.
This value is always 7.
<CellSet> - the last setting done with command #MONI.
Example Set command selects the cell 0
at#moni=0
OK
Execution command reports GSM-related information for
cell 0
at#moni
#MONI: I WIND BSIC:70 RxQual:0 LAC:55FA Id:1D23 ARFCN:736 PWR:-83dbm TA:1
OK
Set command selects the special request to obtain GSM-
related information from the whole set of seven cells in
the neighbour of the serving cell
at#moni=7
OK
Execution command reports the requested information in
table-like format
at#moni
#MONI: Cell BSIC LAC CellId ARFCN Power C1 C2 TA RxQual PLMN
#MONI: S 70 55FA 1D23 736 -83dbm 19 33 1 0 I WIND
#MONI: N1 75 55FA 1297 983 -78dbm 26 20
#MONI: N2 72 55FA 1289 976 -82dbm 22 16
#MONI: N3 70 55FA 1D15 749 -92dbm 10 18
#MONI: N4 72 55FA 1D0D 751 -92dbm 10 18
#MONI: N5 75 55FA 1296 978 -95dbm 9 3
#MONI: N6 70 55FA 1D77 756 -99dbm 3 11
OK
Note The refresh time of the measures is preset to 3 sec.
The timing advance value is meaningful only during calls or GPRS transfers
active.
#MONI - Cell Monitor
SELINT 2
AT#MONI[=
[<number>]] #MONI is both a set and an execution command.