Rainbow Electronics GM862-QUAD-PY - Manual (Page 90)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 90 of 434
@CLCK - Facility Improved Lock/Unlock SELINT 0 / 1
"AO"- BAOC (Barr All Outgoing Calls)
"OI" - BOIC (Barr Outgoing International Calls)
"OX" - BOIC-exHC (Barr Outgoing International Calls except to Home
Country)
"AI" - BAIC (Barr All Incoming Calls)
"IR" - BIC-Roam (Barr Incoming Calls when Roaming outside the home
country)
"AB" - All Barring services (applicable only for <mode>=0)
"AG" - All outGoing barring services (applicable only for <mode>=0)
"AC" - All inComing barring services (applicable only for <mode>=0)
"FD" - SIM fixed dialling memory feature (if PIN2 authentication has not
been done during the current session, PIN2 is required as
<passwd>)
"PN" - network Personalisation
"PU" - network subset Personalisation
<mode> - defines the operation to be done on the facility
0 - unlock facility
1 - lock facility
2 - query status
<passwd> - shall be the same as password specified for the facility from
the DTE user interface or with command Change Password
+CPWD
<class> - sum of integers each representing a class of information (default
is 7)
1- voice (telephony)
2 - data (refers to all bearer services)
4 - fax (facsimile services)
8 - short message service
16 - data circuit sync
32 - data circuit async
64 - dedicated packet access
128 - dedicated PAD access
Note: when <mode>=2 and command successful, it returns:
@CLCK: <status>[,<class1>
[<CR><LF>@CLCK: <status>,<class2>[…]]
where
<status> - the current status of the facility
0 - not active
1 - active
<classn> - class of information of the facility
AT@CLCK=? Test command reports all the facilities supported by the device.
Reference GSM 07.07