Rainbow Electronics GM862-QUAD-PY - Manual (Page 245)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 245 of 434
#SRS - Select Ringer Sound SELINT 2
Note: If all parameters are omitted then the behaviour of Set command is
the same as Read command
AT#SRS? Read command reports current selected ringing and its status in the form:
#SRS: <n>,<status>
where:
<n> - ringing tone number
1..max
<status> - ringing status
0 - selected but not playing
1 - currently playing
AT#SRS=? Test command reports the supported values for the parameters <n> and
<tout>
3.5.7.1.12 Select Ringer Path - #SRP
#SRP - Select Ringer Path SELINT 0 / 1
AT#SRP[=[<n>]] Set command selects the ringer path towards whom sending ringer sounds
and all signalling tones.
Parameter:
<n> - ringer path number
0 - sound output towards current selected audio path (see
command #CAP)
1 - sound output towards handsfree
2 - sound output towards handset
3 - sound output towards Buzzer Output pin GPIO7
Note: In order to use the Buzzer Output an external circuitry must be
added to drive it properly from the GPIO7 pin, furthermore the GPIO7 pin
direction must be set to Buzzer output (Alternate function); see command
#GPIO.
Note: issuing AT#SRP<CR> is the same as issuing the Read command.
Note: issuing AT#SRP=<CR> is the same as issuing the command
AT#SRP=0<CR>.
AT#SRP? Read command reports the selected ringer path in the format:
#SRP: <n>.
AT#SRP=? Test command reports the supported values for the parameter <n>.
Example AT#SRP=?
#SRP: (0-3)
OK