Rainbow Electronics GM862-QUAD-PY - Manual (Page 346)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 346 of 434
3.5.7.5.13 Socket Parameters Reset - #SKTRST
#SKTRST - Socket Parameters Reset SELINT 0 / 1
AT#SKTRST Execution command resets the socket parameters to the “factory default”
configuration and stores them in the NVM of the device.
The socket parameters to reset are:
- User ID
- Password
- Packet Size
- Socket Inactivity Time-Out
- Data Sending Time-Out
- Socket Type
- Remote Port
- Remote Address
- TCP Connection Time-Out
Example AT#SKTRST
OK
socket parameters have been reset
#SKTRST - Socket Parameters Reset
SELINT 2
AT#SKTRST Execution command resets the socket parameters to the “factory default”
configuration and stores them in the NVM of the device.
The socket parameters to reset are:
- User ID
- Password
- Packet Size
- Socket Inactivity Time-Out
- Data Sending Time-Out
- Socket Type
- Remote Port
- Remote Address
- TCP Connection Time-Out
AT#SKTRST=? Test command returns the OK result code.
Example AT#SKTRST
OK
socket parameters have been reset
3.5.7.5.14 GPRS Context Activation - #GPRS
#GPRS - GPRS Context Activation SELINT 0 / 1
AT#GPRS[=
[<mode>]] Execution command deactivates/activates the GPRS context, eventually
proceeding with the authentication with the parameters given with #PASSW
and #USERID.
Parameter:
<mode> - GPRS context activation mode