Rainbow Electronics GM862-QUAD-PY User Manual
Page 405
AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 405 of 434
#STSR - SIM Tookit Send Response
SELINT 2
[,<data>]]
Parameters:
<cmdType> - integer type; proactive command ID according to GSM
11.14 (see #STGI)
<userResponse> - action performed by the user
0 - command performed successfully (call accepted in case of call setup)
16 - proactive SIM session terminated by user
17 - backward move in the proactive SIM session requested by the user
18 - no response from user
19 - help information required by the user
20 - USSD/SS Transaction terminated by user
32 - TA currently unable to process command
34 - user has denied SIM call setup request
35 - user cleared down SIM call before connection or network release
<data> - data entered by user, depending on <cmdType>, only required if
<Result> is 0:
Get Inkey
<data> contains the key pressed by the user; used character set should be
the one selected with +CSCS.
Note: if, as a user response, a binary choice (Yes/No) is requested by the
SIM application using bit 3 of the <commandDetails> parameter the valid
content of the <inputString> is:
a) “IRA”, ”8859-1”, ”PCCP437” charsets: “Y” or “y” (positive answer) and “N”
or “n” (negative answer)
b) UCS2 alphabet “0079” or “0059” (positive answer) and “006E” or “004E”
(negative answer)
Get Input
<data> - contains the string of characters entered by the user (see above)
Select Item
<data> - contains the item identifier selected by the user
Note:
Use of icons is not supported. All icon related actions will respond with no
icon available.
AT#STSR?
The read command can be used to request the currently ongoing proactive
command and the SAT state in the format
#STSRI: <state>,<cmdType>
where:
<state> - SAT interface state (see #STIA)
<cmdType> - ongoing proactive command
An error message will be returned if there is no pending command.
AT#STSR=?
Test command returns the range for the parameters <state> and