Rainbow Electronics GM862-QUAD-PY - Manual (Page 42)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 42 of 434
V - Response Format SELINT 0 / 1 / 2
codes are transmitted in a numeric form or an alphanumeric form (see
[§3.2.3 Information Responses And Result Codes] for the table of result
codes).
Parameter:
<n>
0 - limited headers and trailers and numeric format of result codes
information responses <text><CR><LF>
result codes <numeric code><CR>
1 - full headers and trailers and verbose format of result codes (factory
default)
information responses <CR><LF>
<text><CR><LF>
result codes <CR><LF>
<verbose code><CR><LF>
Note: the <text> portion of information responses is not affected by this
setting.
Note: if parameter is omitted, the command has the same behaviour of
ATV0
Reference V25ter
3.5.3.2.4 Extended Result Codes - X
X - Extended Result Codes SELINT 0 / 1 / 2
ATX[<n>]
Set command selects the result code messages subset used by the modem
to inform the DTE of the result of the commands.
Parameter:
<n> - (factory default is 1)
0 - on entering dial-mode CONNECT result code is given; OK, CONNECT,
RING, NO CARRIER, ERROR, NO ANSWER result codes are enabled
. Dial tone and busy detection (NO DIALTONE and BUSY result
codes) are disabled.
1..4 - on entering dial-mode CONNECT <text> result code is given; all the
other result codes are enabled.
Note: If parameter is omitted, the command has the same behaviour of