Rainbow Electronics GM862-QUAD-PY - Manual (Page 242)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 242 of 434
#CEER – Extended numeric error report SELINT 2
229 PDP deactivation requested by NWK
230 PDP deactivation cause LLC link activation Failed
231 PDP deactivation cause NWK reactivation with same TI
232 PDP deactivation cause GMM abort
233 PDP deactivation cause LLC or SNDCP failure
234 PDP unsuccessful activation cause GMM error
235 PDP unsuccessful activation cause NWK reject
236 PDP unsuccessful activation cause NO NSAPI
available
237 PDP unsuccessful activation cause SM refuse
238 PDP unsuccessful activation cause MMI ignore
239 PDP unsuccessful activation cause Nb Max Session
Reach
Other custom values
240 FDN is active and number is not in FDN
241 Call operation not allowed
252 Call barring on outgoing calls
253 Call barring on incoming calls
254 Call impossible
255 Lower layer failure
AT#CEER=? Test command returns OK result code.
Reference GSM 04.08
3.5.7.1.10 Change Audio Path - #CAP
#CAP - Change Audio Path SELINT 0 / 1
AT#CAP[=[<n>]] Set command switches the active audio path depending on parameter <n>
Parameter:
<n> - audio path
0 - audio path follows the AXE input (factory default):
• if AXE is low, handsfree is enabled;
• if AXE is high, internal path is enabled
1 - enables handsfree external mic/ear audio path
2 - enables internal mic/ear audio path
Note: The audio path are mutually exclusive, enabling one disables the
other.
Note: when changing the audio path, the volume level is set at the
previously stored value for that audio path (see +CLVL).
Note: issuing AT#CAP<CR> is the same as issuing the Read command.
Note: issuing AT#CAP=<CR> is the same as issuing the command
AT#CAP=0<CR>.