Rainbow Electronics GM862-QUAD-PY - Manual (Page 385)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 385 of 434
#CSURVC - Network Survey (Numeric Format) SELINT 2
number, else it is a 4-digits hexadecimal number
<cellId> - cell identifier; if #CSURVF last setting is 0, <cellId> is a decimal
number, else it is a 4-digits hexadecimal number
<cellStatus> - string type; it is the cell status
..0 - C0 is a suitable cell (CELL_SUITABLE).
1 - the cell is low priority based on the received system information
(CELL_LOW_PRIORITY).
2 - the cell is forbidden (CELL_FORBIDDEN).
3 - the cell is barred based on the received system information
(CELL_BARRED).
4 - the cell <rxLev> is low (CELL_LOW_LEVEL).
5 - none of the above e.g. exclusion timer running, no BCCH
available…etc.. (CELL_OTHER).
<numArfcn> - decimal number; it is the number of valid channels in the
Cell Channel Description
<arfcnn> - decimal number; it is the arfcn of a valid channel in the Cell
Channel Description (n is in the range 1..<numArfcn>)
<numChannels> - decimal number; it is the number of valid channels in
the BCCH Allocation list; the output of this information for non-
serving cells depends on last #CSURVEXT setting:
3. if #CSURVEXT=0 this information is displayed only for
serving cell
4. if #CSURVEXT=1 or 2 this information is displayed also for
every valid scanned BCCH carrier.
<ban> - decimal number; it is the arfcn of a valid channel in the BA list (n
is in the range 1..<numChannels>); the output of this
information for non-serving cells depends on last #CSURVEXT
setting:
1. if #CSURVEXT=0 this information is displayed only for
serving cell
2. if #CSURVEXT=1 or 2 this information is displayed also for
every valid scanned BCCH carrier.
(The following informations will be printed only if GPRS is supported in the
cell)
<pbcch> - packet broadcast control channel
0 - pbcch not activated on the cell
1 - pbcch activated on the cell
<nom> - network operation mode
1
2
3
<rac> - routing area code
0..255 -
<spgc> - SPLIT_PG_CYCLE support
..0 - SPLIT_PG_CYCLE is not supported on CCCH on this cell
..1 - SPLIT_PG_CYCLE is supported on CCCH on this cell
<pat> - priority access threshold