Rainbow Electronics GM862-QUAD-PY - Manual (Page 40)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 40 of 434
%L - Line Signal Level SELINT 0 / 1 / 2
AT%L It has no effect and is included only for backward compatibility with landline
modems
3.5.3.1.22 Line Quality - %Q
%Q - Line Quality SELINT 0 / 1 / 2
AT%Q It has no effect and is included only for backward compatibility with landline
modems
3.5.3.1.23 Speaker Loudness - L
L - Speaker Loudness SELINT 0 / 1 / 2
ATL<n> It has no effect and is included only for backward compatibility with landline
modems
3.5.3.1.24 Speaker Mode - M
M - Speaker Mode SELINT 0 / 1 / 2
ATM<n> It has no effect and is included only for backward compatibility with landline
modems
3.5.3.2 DTE - Modem Interface Control
3.5.3.2.1 Command Echo - E
E - Command Echo SELINT 0 / 1 / 2
ATE[<n>]
Set command enables/disables the command echo.
Parameter:
<n>
0 - disables command echo
1 - enables command echo (factory default) , hence command sent to the
device are echoed back to the DTE before the response is given.
Note: if parameter is omitted, the command has the same behaviour of
ATE0
Reference V25ter
3.5.3.2.2 Quiet Result Codes - Q
Q - Quiet Result Codes SELINT 0 / 1
ATQ[<n>]
Set command enables or disables the result codes.
Parameter: