Rainbow Electronics GM862-QUAD-PY - Manual (Page 67)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 67 of 434
S38 -Delay Before Forced Hang Up SELINT 0 / 1
command (or ON-to-OFF transition of DTR if device is programmed to
follow the signal) and the disconnect operation.
Parameter:
<delay> - expressed in seconds
0..254 - the device will wait <delay> seconds for the remote device to
acknowledge all data in the device buffer before disconnecting
(factory default value is 20).
255 - the device doesn’t time-out and continues to deliver data in the buffer
until the connection is lost or the data is delivered.
Note: <delay> parameter can be used to ensure that data in device buffer is
sent before device disconnects.
ATS38? Read command returns the current value of S38 parameter.
ATS38=? Test command returns the range of supported values for <delay> without
command echo and parenthesis.
Note For either Read and Test command the format of the numbers in output is
always 3 digits, left-filled with 0s
S38 -Delay Before Forced Hang Up
SELINT 2
ATS38=[<delay>] Set command sets the delay, in seconds, between the device’s receipt of H
command (or ON-to-OFF transition of DTR) and the disconnect operation.
Parameter:
<delay> - acknowledge timer in units of seconds
0..254 - the device will wait <delay> seconds for the remote device to
acknowledge all data in the device buffer before disconnecting
(factory default value is 20).
255 - the device doesn’t time-out and continues to attempt to deliver data
in the buffer until the connection is lost or the data is delivered.
Note: <delay> parameter can be used to ensure that data in device buffer is
sent before device disconnects.
ATS38? Read command returns the current value of S38 parameter.
Note: the format of the numbers in output is always 3 digits, left-filled with 0s