Rainbow Electronics GM862-QUAD-PY User Manual
Page 398
AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 398 of 434
#STIA - SIM Tookit Interface Activation
SELINT 2
where
<cmdTerminateValue>
150 - SMS control response
160 - call/SS/USSD response
<Result>
0 - Call/SMS not allowed
1 - Call/SMS allowed
2 - Call/SMS allowed with modification
<Number> - Called number, Service Center Address or SS String in ASCII
format.
<MODestAddr> - MO destination address in ASCII format.
<TextInfo> - alpha identifier provided by the SIM in ASCII format.
Note: when the SIM Application enters its main menu again (i.e. not at
startup) an unsolicited result code
#STN: 254
is sent.
The TA does not need to respond directly, i.e. AT#STSR is not required.
It is possible to restart the SAT session from the main menu again with the
command AT#STGI=37.
Note: The settings are saved on user profile and available on following
reboot. SIM Toolkit activation/deactivation is only performed at power on.
AT#STIA?
Read command can be used to get information about the SAT interface in
the format:
#STIA: <state>,<mode>,<timeout>,<SatProfile>
where:
<state> - the device is in one of the following state:
0 - SIM has not started its application yet
1 - SIM has started its application (SAT main menu ready)
<mode> - SAT and unsolicited indications enabling status (see above)
<timeout> - time-out for user responses (see above)
<SatProfile> - SAT Terminal Profile according to GSM 11.14, i. e. the list of
SIM Application Toolkit facilities that are supported by the ME.
The profile cannot be changed by the TA.
Note: In SAT applications usually an SMS message is sent to the network
provider containing service requests, e.g. to send the latest news. The
provider returns a message with the requested information.
Before activating SAT it is recommended to set the SMS text mode with
command AT+CMGF=1 and to enable unsolicited indications for incoming