Rainbow Electronics GM862-QUAD-PY - Manual (Page 381)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 381 of 434
#CSURV - Network Survey SELINT 2
if #CSURVF=2
the output ends with the string:
Network survey ended (Carrier: <NoARFCN> BCCh: <NoBCCh>)
where
<NoARFCN> - number of scanned frequencies
<NoBCCH> - number of found BCCh
Example AT#CSURV
Network survey started…
arfcn: 48 bsic: 24 rxLev: -52 ber: 0.00 mcc: 610 mnc: 1
lac: 33281 cellId: 3648 cellStatus: CELL_SUITABLE
numArfcn: 2 arfcn: 30 48 numChannels: 5 array: 14 19 22
48 82
arfcn: 14 rxLev: 8
Network survey ended
OK
Note The command is executed within max. 2 minute.
3.5.7.7.2 Network Survey (Numeric Format) - #CSURVC
#CSURVC - Network Survey (Numeric Format) SELINT 0 / 1
AT#CSURVC
[=<s>,<e>]
AT*CSURVC
[=<s>,<e>]
(both syntax are
possible) Execution command allows to perform a quick survey through channels
belonging to the band selected by last #BND command issue, starting from
channel <s> to channel <e>. If parameters are omitted, a full band scan is
performed.
Parameters:
<s> - starting channel
<e> - ending channel
After issuing the command the device responds with the string:
Network survey started…
and, after a while, a list of informations, one for each received carrier, is
reported, each of them in the format:
(For BCCH-Carrier)
<arfcn>,<bsic>,<rxLev>,<ber>,<mcc>,<mnc>,<lac>,<cellId>,