Rainbow Electronics GM862-QUAD-PY - Manual (Page 418)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 418 of 434
#CMUXSCR - CMUX Interface Enable SELINT 2
<enable>,[<rate>] channel (see +CMUX) at startup before the current script (see #ESCRIPT)
execution and specifies the DTE speed at which the device sends and
receives CMUX frames (used to fix the DTE-DCE interface speed).
Parameters:
<enable> - enables/disables CMUX interface at startup.
0 - it disables CMUX interface at startup, before current script execution
(factory default)
1 - it enables CMUX interface at startup, before current script execution
<rate>
300
1200
2400
4800
9600
19200
38400
57600
115200 (default)
If <rate> is omitted the value is unchanged
<enable> and <rate> values are saved in NVM
AT#CMUXSCR ? Read command returns the current value of #CMUXSCR parameters in the
format:
#CMUXSCR: <enable>,<rate>
AT#CMUXSCR =? Test command reports the range for the parameters <enable> and <rate>
3.5.7.11 GPS AT Commands Set
3.5.7.11.1 GPS Controller Power Management - $GPSP
$GPSP - GPS Controller Power Management SELINT 0 / 1 / 2
AT$GPSP=<status>
Set command allows to manage power-up or down of the GPS controller
Parameter:
<status>
0 - GPS controller is powered down
1 - GPS controller is powered up (default)
Note: for the GPS product (GE863-GPS): if the GPS controller is powered
down while VAUX pin is enabled they’ll both also be also powered off.