Rainbow Electronics GM862-QUAD-PY - Manual (Page 375)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 375 of 434
3.5.7.6.10 SMTP Read Message - #EMAILMSG
#EMAILMSG - SMTP Read Message SELINT 0 / 1
AT#EMAILMSG Execution command returns the last response from SMTP server.
AT#EMAILMSG? Read command has the same behaviour as Execution command.
#EMAILMSG - SMTP Read Message
SELINT 2
AT#EMAILMSG Execution command returns the last response from SMTP server.
AT#EMAILMSG=? Test command returns the OK result code.
3.5.7.7 Easy Scan® Extension AT Commands
Note: it is strongly suggested to issue all the Easy Scan® Extension AT commands with NO
SIM inserted, to avoid a potential conflict with normal module operations, such as “incoming
call”, “periodic location update, “periodic routing area update” and so on.
3.5.7.7.1 Network Survey - #CSURV
#CSURV - Network Survey SELINT 0 / 1
AT#CSURV
[=<s>,<e>]
AT*CSURV
[=<s>,<e>]
(both syntax are
possible) Execution command allows to perform a quick survey through channels
belonging to the band selected by last #BND command issue, starting from
channel <s> to channel <e>. If parameters are omitted, a full band scan is
performed.
Parameters:
<s> - starting channel
<e> - ending channel
After issuing the command the device responds with the string:
Network survey started…
and, after a while, a list of informations, one for each received carrier, is
reported, each of them in the format:
(For BCCH-Carrier)
arfcn: <arfcn> bsic: <bsic> rxLev: <rxLev> ber: <ber> mcc: <mcc>
mnc: <mnc> lac: <lac> cellId: <cellId> cellStatus: <cellStatus>
numArfcn: <numArfcn> arfcn: [<arfcn1> ..[ <arfcn64>]]
[numChannels: <numChannels> array: [<ba1> ..[<ba32>]] [pbcch:
<pbcch> [nom: <nom> rac: <rac> spgc: <spgc> pat: <pat> nco: <nco>
t3168: <t3168> t3192: <t3192> drxmax: <drxmax> ctrlAck: <ctrlAck>
bsCVmax: <bsCVmax> alpha: <alpha> pcMeasCh: <pcMeasCh>]]]