Rainbow Electronics GM862-QUAD-PY - Manual (Page 65)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 65 of 434
S12 - Escape Prompt Delay
SELINT 2
ATS12=[<time>] Set command sets:
1) the minimum period, before receipt of the first character of the three
escape character sequence, during which no other character has to
be detected in order to accept it as valid first character;
2) the maximum period allowed between receipt of first or second
character of the three escape character sequence and receipt of the
next;
3) the minimum period, after receipt of the last character of the three
escape character sequence, during which no other character has to
be detected in order to accept the escape sequence as a valid one.
Parameter:
<time> - expressed in fiftieth of a second
20..255 - factory default value is 50.
Note: the minimum period S12 has to pass after CONNECT result
code too, before a received character is accepted as valid first
character of the three escape character sequence.
ATS12? Read command returns the current value of S12 parameter.
Note: the format of the numbers in output is always 3 digits, left-filled with 0s
3.5.3.7.3 Delay To DTR Off - S25
S25 - Delay To DTR Off SELINT 0 / 1
ATS25[=<time>] Set command defines the amount of time, in hundredths of second, that the
device will ignore the DTR for taking the action specified by command &D.
Parameter:
<time> - expressed in hundredths of a second
0..255 - factory default value is 5.
Note: the delay is effective only if its value is greater than 5.
ATS25? Read command returns the current value of S25 parameter.
ATS25=? Test command returns the range for <time> without command echo and
parenthesis.
Note: the output depends on the choice made through #SELINT command.
Note For either Read and Test command the format of the numbers in output is
always 3 digits, left-filled with 0s
S25 -Delay To DTR Off
SELINT 2
ATS25=[<time>] Set command defines the amount of time, in hundredths of second, that the
device will ignore the DTR for taking the action specified by command &D.