Rainbow Electronics GM862-QUAD-PY - Manual (Page 83)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 83 of 434
+CREG - Network Registration Report SELINT 2
(the MODULE is in network searching state)
at+creg?
+CREG: 0,2
OK
at+creg?
+CREG: 0,2
OK
at+creg?
+CREG: 0,2
OK
at+creg?
+CREG: 0,1
OK
(the MODULE is registered)
at+creg?
+CREG: 0,1
OK
Reference GSM 07.07
Note There are situations in which the presentation of the URC controlled by
+CREG is slightly different from ETSI specifications: e.g. it is possible to
have an excessive presentation of the URC +CREG: 4. We identified this
behaviour and decided to maintain it as default for backward compatibility
issues. It is indeed possible to avoid it simply issuing AT#REGMODE=1
(see #REGMODE): this puts the Operation Mode of Registration Status
Commands in ‘Enhanced Registration Operation Mode’ which is more
formal.
3.5.4.3.4 Operator Selection - +COPS
+COPS - Operator Selection SELINT 0 / 1
AT+COPS[=
[<mode>
[,<format>
[,<oper>]]]]
Set command forces an attempt to select and register the GSM network
operator.
<mode> parameter defines whether the operator selection is done
automatically or it is forced by this command to operator <oper>.
The operator <oper> shall be given in format <format>.
The behaviour of +COPS command depends on the last #COPSMODE
setting.
(#COPSMODE=0)
Parameters:
<mode>
0 - automatic choice (the parameter <oper> will be ignored) (factory