Rainbow Electronics GM862-QUAD-PY - Manual (Page 285)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 285 of 434
#ECAM - Extended Call Monitoring SELINT 0 / 1
#ECAM: <ccid>,<ccstatus>,<calltype>,,, [<number>,<type>]
where
<ccid> - call ID
<ccstatus> - call status
0 - idle
1 - calling (MO)
2 - connecting (MO)
3 - active
4 - hold
5 - waiting (MT)
6 - alerting (MT)
7 - busy
<calltype> - call type
1 - voice
2 - data
<number> - called number (valid only for <ccstatus>=1)
<type> - type of <number>
129 - national number
145 - international number
Note: the unsolicited indication is sent along with usual codes (OK, NO
CARRIER, BUSY...).
Note: issuing AT#ECAM<CR> is the same as issuing the Read
command.
Note: issuing AT#ECAM=<CR> returns the OK result code.
AT#ECAM? Read command reports whether the extended call monitoring function is
currently enabled or not, in the format:
#ECAM: <onoff>
AT#ECAM=? Test command returns the list of supported values for <onoff>
#ECAM - Extended Call Monitoring SELINT 2
AT#ECAM=
[<onoff>] This command enables/disables the call monitoring function in the ME.
Parameter:
<onoff>
0 - disables call monitoring function (factory default)
1 - enables call monitoring function; the ME informs about call events,
such as incoming call, connected, hang up etc. using the following
unsolicited indication:
#ECAM: <ccid>,<ccstatus>,<calltype>,,,[<number>,<type>]