Rainbow Electronics GM862-QUAD-PY - Manual (Page 52)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 52 of 434
D – Dial SELINT 0 / 1
I - invocation, restrict CLI presentation
i - suppression, allow CLI presentation
ATD<number>G[;]
ATD<number>g[;] Issues a call checking the CUG supplementary service information for the
current call. Refer to +CCUG command.
If “;” is present a VOICE call is performed.
ATD*<gprs_sc>
[*<addr>][*[<L2P>]
[*[<cid>]]]]# This command is specific of GPRS functionality and causes the MT to
perform whatever actions are necessary to establish communication
between the TE and the external PDN.
Parameters:
<gprs_sc> - GPRS Service Code, a digit string (value 99) which identifies
a request to use the GPRS
<addr> - string that identifies the called party in the address space
applicable to the PDP.
<L2P> - a string which indicates the layer 2 protocol to be used (see
+CGDATA command). For communications software that
does not support arbitrary characters in the dial string, the
following numeric equivalents shall be used:
1 - PPP
<cid> - a digit which specifies a particular PDP context definition (see
+CGDCONT command).
Example To dial a number in SIM phonebook entry 6:
ATD>SM6
OK
To have a voice call to the 6-th entry of active
phonebook:
ATD>6;
OK
To call the entry with alphanumeric field “Name”:
ATD>”Name”;
OK
Reference V25ter.
D – Dial
SELINT 2
ATD<number>[;] Execution command starts a call to the phone number given as parameter.
If “;” is present, a voice call to the given number is performed, regardless
of the current value of the connection mode set by +FCLASS command.
Parameter:
<number> - phone number to be dialed
Note: type of call (data, fax or voice) depends on last +FCLASS setting.