Rainbow Electronics GM862-QUAD-PY - Manual (Page 137)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 137 of 434
+CALA - Alarm Management SELINT 2
the week; the digits 1 to 7 corresponds to the days in the week
(Monday is 1).
“0” - it sets a recurrent alarm for all days in the week.
<silent> - integer type indicating if the alarm is silent or not.
0 - the alarm will not be silent;
1 - the alarm will be silent.
During the "alarm mode" the device will not make any network scan and will
not register to any network and therefore is not able to dial or receive any
call or SMS, the only commands that can be issued to the MODULE in this
state are the #WAKE and #SHDN, every other command must not be
issued during this state.
Note: it is mandatory to set at least once the RTC (issuing +CCLK) before it
is possible to issue +CALA with <type>=8
AT+CALA? Read command returns the list of current active alarm settings in the ME, in
the format:
[+CALA: <time>,<n>,<type>,[<text>],<recurr>,<silent>]
AT+CALA=? Test command returns the list of supported index values (currently just 0),
alarm types, maximum length of the text to be displayed, maximum length
of <recurr> and supported <silent>s, in the format:
+CALA: (list of supported <n>s),(list of supported <type>s),<tlength>,
<rlength>,(list of supported <silent>s)
Example AT+CALA="02/09/07,23:30:00+00"
OK
Reference ETSI 07.07, ETSI 27.007
3.5.4.4.13 Restricted SIM Access - +CRSM
+CRSM - Restricted SIM Access SELINT 0 / 1 / 2
AT+CRSM=
<command>
[,<fileid>
[,<P1>,<P2>,<P3>
[,<data>]]] Execution command transmits to the ME the SIM <command> and its
required parameters. ME handles internally all SIM-ME interface locking and
file selection routines. As response to the command, ME sends the actual
SIM information parameters and response data.
Parameters:
<command> - command passed on by the ME to the SIM
176 - READ BINARY
178 - READ RECORD
192 - GET RESPONSE
214 - UPDATE BINARY
220 - UPDATE RECORD
242 - STATUS
<fileid> - identifier of an elementary data file on SIM. Mandatory for every