Rainbow Electronics GM862-QUAD-PY - Manual (Page 262)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 262 of 434
#DVI - Digital Voiceband Interface SELINT 2
1 - DVI port 1 will be used (factory default)
2 - DVI port 2 will be used
<clockmode>
0 - DVI slave
1 - DVI master (factory default)
Note: setting <clockmode>=0 has full effect only if <dviport>=1
AT#DVI? Read command reports last setting, in the format:
#DVI: <mode>,<dviport>,<clockmode>
AT#DVI=? Test command reports the range of supported values for parameters
<mode>,<dviport> and <clockmode>
Example AT#DVI=2,1,1
OK
Both analog and DVI activated for audio. DVI is
configured as master providing on DVI Port #1
3.5.7.1.31 SMS Ring Indicator - #E2SMSRI
#E2SMSRI - SMS Ring Indicator SELINT 0 / 1
AT#E2SMSRI[=
[<n>]] Set command enables/disables the Ring Indicator pin response to an
incoming SMS message. If enabled, a negative going pulse is generated on
receipt of an incoming SMS message. The duration of this pulse is
determined by the value of <n>.
Parameter:
<n> - RI enabling
0 - disables RI pin response for incoming SMS messages (factory default)
50..1150 - enables RI pin response for incoming SMS messages. The
value of <n> is the duration in ms of the pulse generated on receipt of
an incoming SM.
Note: if +CNMI=3,1 command is issued and the module is in a GPRS
connection, a 100 ms break signal is sent and a 1 sec. pulse is generated
on RI pin, no matter if the RI pin response is either enabled or not.
Note: issuing AT#E2SMSRI<CR> is the same as issuing the Read
command.
Note: issuing AT#E2SMSRI=<CR> returns the OK result code.
AT#E2SMSRI? Read command reports the duration in ms of the pulse generated on
receipt of an incoming SM, in the format:
#E2SMSRI: <n>