45 +cops mode - #copsmode – Rainbow Electronics GM862-QUAD-PY User Manual
Page 279
AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 279 of 434
#SERVINFO - Serving Cell Information
SELINT 0 / 1
..0
..3..6
AT#SERVINFO?
Read command has the same effect as Execution command
#SERVINFO - Serving Cell Information
SELINT 2
AT#SERVINFO
Execution command reports information about serving cell, in the format:
#SERVINFO: <B-ARFCN>,<dBM>,<NetNameAsc>,<NetCode>,
,<BSIC>,<LAC>,<TA>,<GPRS>[,[<PB-ARFCN>],[<NOM>],
<RAC>,[PAT]]
where:
<B-ARFCN> - BCCH ARFCN of the serving cell
<dBM> - received signal strength in dBm
<NetNameAsc> - operator name, quoted string type
<NetCode> - country code and operator code, hexadecimal
representation
<BSIC> - Base Station Identification Code
<LAC> - Localization Area Code
<TA> - Time Advance: it’s available only if a GSM or GPRS is running
<GPRS> - GPRS supported in the cell
0 - not supported
1 - supported
The following information will be present only if GPRS is supported in the
cell
<PB-ARFCN> - PBCCH ARFCN of the serving cell; it’ll be printed only if
PBCCH is supported by the cell, otherwise the label “hopping” will
be printed
<NOM> - Network Operation Mode
..”I”
“II”
..”III”
<RAC> - Routing Area Colour Code
<PAT> - Priority Access Threshold
..0
..3..6
3.5.7.1.45 +COPS Mode - #COPSMODE
#COPSMODE - +COPS Mode
SELINT 0 / 1
AT#COPSMODE
[=<mode>]
Set command sets the behaviour of +COPS command (see +COPS).
Parameter:
<mode>
0 - +COPS behaviour like former GM862 family products (default)