Rainbow Electronics GM862-QUAD-PY - Manual (Page 264)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 264 of 434
#ADC - Analog/Digital Converter Input SELINT 0 / 1
2 - available only for GE863-QUAD, GE863-PY, GE864-QUAD, GE864-
PY, GC864-QUAD and GC864-PY
3 - available only for GE863-QUAD, GE863-PY, GE864-QUAD, GE864-
PY, GC864-QUAD and GC864-PY
<mode> - required action
2 - query ADC value
<dir> - direction; its interpretation is currently not implemented
0 - no effect.
If all parameters are omitted the command reports all pins voltage,
converted by ADC, in the format:
#ADC: <value>[<CR><LF>#ADC: <value>[…]]
Note: The command returns the last valid measure.
AT#ADC? Read command has the same effect as Execution command when all
parameters are omitted.
AT#ADC=? Test command reports the supported range of values of the command
parameters <adc>, <mode> and <dir>.
#ADC - Read Analog/Digital Converter input
SELINT 2
AT#ADC=
[<adc>,<mode>
[,<dir>]]
Execution command reads pin<adc> voltage, converted by ADC, and
outputs it in the format:
#ADC: <value>
where:
<value> - pin<adc> voltage, expressed in mV
Parameters:
<adc> - index of pin
1 - available for GM862-QUAD, GM862-QUAD-PY, GM862-GPS, GE863-
QUAD, GE863-PY, GE863-GPS, GE864-QUAD, GE864-PY, GC864-
QUAD and GC864-PY
2 - available only for GE863-QUAD, GE863-PY, GE864-QUAD, GE864-
PY, GC864-QUAD and GC864-PY
3 - available only for GE863-QUAD, GE863-PY, GE864-QUAD, GE864-
PY, GC864-QUAD and GC864-PY
<mode> - required action
2 - query ADC value
<dir> - direction; its interpretation is currently not implemented
0 - no effect.
Note: The command returns the last valid measure.
AT#ADC? Read command reports all pins voltage, converted by ADC, in the format: