Rainbow Electronics GM862-QUAD-PY - Manual (Page 428)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 428 of 434
$GPSRST - Restore To Default GPS Parameters SELINT 0 / 1 / 2
Note The module must be restarted to use the new configuration
3.5.7.11.18 GPS Controller Disabled When the Module is Woken up by
Charger Insertion - $GPSCMODE
$GPSCMODE - GPS Controller Disabled at Start-up With Charger Inserted SELINT 0 / 1 / 2
AT$GPSCMODE=<
n> Execution command allows to keep off the GSP controller when the module
is woken up by charger insertion.
The GPS controller can be turned on by AT$GPSP=1.
Parameter:
<n>
0 – GPS controller on at start-up (factory default)
1 – GSP controller off at start-up with charger inserted
Note: the new setting is stored through $GPSSAV
AT$GPSCMODE ? Read command reports whether GPS controller is enabled or not when the
module is turned on by the charger insertion, in the format:
$GPSCMODE : <n>
AT$GPSCMODE =? reports the supported values for <n> parameter..
3.5.7.12 SAP AT Commands Set
3.5.7.12.1 Remote SIM Enable - #RSEN
#RSEN – Remote SIM Enable SELINT 2
AT#RSEN=<mode>
[,<sapformat>
[,<role>
[,<muxch>
[,<beacon>
[,<scriptmode>]]]]] Set command is used to enable/disable the Remote SIM feature. The
command returns ERROR if requested on a non multiplexed interface
Parameter:
<mode>
0 - disable
1 - enable
<sapformat>
1 - binary SAP (default)
<role>
0 - remote SIM Client (default)
• If the ME doesn’t support the Easy Script Extension® or
• <scriptmode> is omitted or
• <scriptmode> is 0
<muxch> - MUX Channel Number; mandatory if <mode>=1
1..3