Rainbow Electronics GM862-QUAD-PY - Manual (Page 68)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 68 of 434
3.5.4 ETSI GSM 07.07 AT Commands
3.5.4.1 General
3.5.4.1.1 Request Manufacturer Identification - +CGMI
+CGMI - Request Manufacturer Identification SELINT 0 / 1
AT+CGMI Execution command returns the device manufacturer identification code
without command echo. The output depends on the choice made through
#SELINT command.
AT+CGMI? Read command has the same behaviour as Execution command
Reference GSM 07.07
+CGMI - Request Manufacturer Identification
SELINT 2
AT+CGMI Execution command returns the device manufacturer identification code
without command echo. The output depends on the choice made through
#SELINT command.
AT+CGMI=? Test command returns OK result code.
Reference GSM 07.07
3.5.4.1.2 Request Model Identification - +CGMM
+CGMM - Request Model Identification SELINT 0 / 1
AT+CGMM Execution command returns the device model identification code without
command echo.
Reference GSM 07.07
+CGMM - Request Model Identification
SELINT 2
AT+CGMM Execution command returns the device model identification code without
command echo.
AT+CGMM=? Test command returns OK result code.
Reference GSM 07.07
3.5.4.1.3 Request Revision Identification - +CGMR
+CGMR - Request Revision Identification SELINT 0 / 1
AT+CGMR Execution command returns device software revision number without
command echo.
AT+CGMR? Read command has the same behaviour as Execution command
Reference GSM 07.07
+CGMR - Request Revision Identification
SELINT 2
AT+CGMR Execution command returns device software revision number without
command echo.
AT+CGMR=? Test command returns OK result code.