Rainbow Electronics GM862-QUAD-PY - Manual (Page 64)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 64 of 434
S7 - Connection Completion Time-Out SELINT 2
ATS7=[<tout>] Set command sets the amount of time, in seconds, that the device shall
allow between either answering a call (automatically or by A command) or
completion of signalling of call addressing information to network (dialling),
and establishment of a connection with the remote device.
Parameter:
<tout> - number of seconds
1..255 - factory default value is 60
ATS7? Read command returns the current value of S7 parameter.
Note: the format of the numbers in output is always 3 digits, left-filled with 0s
Reference V25ter
3.5.3.7.1 – Carrier Off With Firm Time - S10
S10 –Carrier Off With Firm Time SELINT 0 / 1 / 2
ATS10 Execution command has no effect and is included only for backward
compatibility with landline modems
3.5.3.7.2 Escape Prompt Delay - S12
S12 - Escape Prompt Delay SELINT 0 / 1
ATS12[=<time>] Set command sets:
1) the minimum period, before receipt of the first character of the three
escape character sequence, during which no other character has to
be detected in order to accept it as valid first character;
2) the maximum period allowed between receipt of first, or second,
character of the three escape character sequence and receipt of the
next;
3) the minimum period, after receipt of the last character of the three
escape character sequence, during which no other character has to
be detected in order to accept the escape sequence as a valid one.
Parameter:
<time> - expressed in fiftieth of a second
20..255 - factory default value is 50.
Note: after CONNECT result code it is possible to accept the first
character of the three escape character sequence without having to
wait for a minimum period to be passed.
ATS12? Read command returns the current value of S12 parameter.
ATS12=? Test command returns the range for <time> without command echo and
parenthesis.
Note For either Read and Test command the format of the numbers in output is
always 3 digits, left-filled with 0s