Rainbow Electronics GM862-QUAD-PY - Manual (Page 400)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 400 of 434
#STGI - SIM Tookit Get Information SELINT 2
if <cmdType>=1 (REFRESH)
#STGI: <cmdType>,<refresh type>
where:
<refresh type>
0 - SIM Initialization and Full File Change Notification;
1 - File Change Notification;
2 - SIM Initialization and File Change Notification;
3 - SIM Initialization;
4 - SIM Reset
if <cmdType>=16 (SET UP CALL)
#STGI: <cmdType>,<commandDetails>,[<confirmationText>],
<calledNumber>
where:
<commandDetails> - unsigned integer, used as an enumeration
0 Set up call, but only if not currently busy on another call
1 Set up call, but only if not currently busy on another call, with redial
2 Set up call, putting all other calls (if any) on hold
3 Set up call, putting all other calls (if any) on hold, with redial
4 Set up call, disconnecting all other calls (if any)
5 Set up call, disconnecting all other calls (if any), with redial
<confirmationText> - string for user confirmation stage
<calledNumber> - string containing called number
if <cmdType>=17 (SEND SS)
if <cmdType>=18 (SEND USSD)
if <cmdType>=19 (SEND SHORT MESSAGE)
if <cmdType>=20 (SEND DTMF)
if <cmdType>=32 (PLAY TONE)
#STGI: <cmdType>[,<text>]
where:
<text> - text to be displayed to user
if <cmdType>=33 (DISPLAY TEXT)
#STGI: <cmdType>,<cmdDetails>[,<text>]
where: