Rainbow Electronics GM862-QUAD-PY - Manual (Page 189)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 189 of 434
+CNMI - New Message Indications To Terminal Equipment SELINT 2
#
S
M
S
M
O
D
E
=
0
#
S
M
S
M
O
D
E
=
0
#
S
M
S
M
O
D
E
=
0
#
S
M
S
M
O
D
where:
<mems> - memory storage where the new message is stored
(see +CPMS)
<index> - location on the memory where SMS is stored.
2 - SMS-DELIVERs (except class 2 messages and messages in the
“store” message waiting indication group) are routed directly to
the TE using the following unsolicited result code:
(PDU Mode)
+CMT: <alpha>,<length><CR><LF><pdu>
where:
<alpha> - alphanumeric representation of originator/destination
number corresponding to the entry found in MT
phonebook; used character set should be the one
selected with command +CSCS.
<length> - PDU length
<pdu> - PDU message
(TEXT Mode)
+CMT:<oa>,<alpha>,<scts>[,<tooa>,<fo>,<pid>,<dcs>,
<sca>,<tosca>,<length>]<CR><LF><data> (the information
written in italics will be present depending on +CSDH last setting)
where:
<oa> - originating address, string type converted in the currently
selected character set (see +CSCS)
<alpha> - alphanumeric representation of <oa>; used character
set should be the one selected with command +CSCS.
<scts> - arrival time of the message to the SC
<tooa>, <tosca> - type of number <oa> or <sca>:
129 - number in national format
145 - number in international format (contains the "+")
<fo> - first octet of GSM 03.40
<pid> - Protocol Identifier
<dcs> - Data Coding Scheme
<sca> - Service Centre address, string type, converted in the
currently selected character set (see +CSCS)
<length> - text length
<data> - TP-User-Data
• If <dcs> indicates that GSM03.38 default alphabet is used
and <fo> indicates that GSM03.40 TP-User-Data-Header-
Indication is not set (bit 6 of <fo> is 0), each character of
GSM alphabet will be converted into current TE character
set (see +CSCS)
• If <dcs> indicates that 8-bit or UCS2 data coding scheme is
used or <fo> indicates that GSM03.40 TP-User-Data-
Header-Indication is set (bit 6 of <fo> is 1), each 8-bit octet
will be converted into two IRA character long hexadecimal