Rainbow Electronics GM862-QUAD-PY - Manual (Page 207)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 207 of 434
+CMGR - Read Message SELINT 0 / 1
<scts> - arrival time of the message to the SC
<dt> - sending time of the message
<st> - message status as coded in the PDU
<pid> - Protocol Identifier
<dcs> - Data Coding Scheme
<oa> - Originator address, string type represented in the currently selected
character set (see +CSCS)
<da> - Destination address, string type represented in the currently
selected character set (see +CSCS)
<sca> - Service Centre number
<tooa>,<toda >,<tosca> - type of number <oa>,<da>,<sca>
129 - number in national format
145 - number in international format (contains the "+")
<length> - text length
<data> - TP-User_data
Note: in both cases if status of the message is 'received unread', status in
the storage changes to 'received read'.
Note: an error result code is sent on empty record <index>.
AT+CMGR=? Test command returns the OK result code.
Note The improving command @CMGR has been defined
Reference GSM 07.05
+CMGR - Read Message
SELINT 2
Note: the behaviour of command +CMGR differs depending on whether or not the improved SMS
commands operation mode has been enabled (see #SMSMODE)
(#SMSMODE=0)
#
S
M
S
M
O
D
E
=
0
#
S
M
S
AT+CMGR=
<index> Execution command reports the message with location value <index>
from <memr> message storage (<memr> is the message storage for
read and delete SMs as last settings of command +CPMS).
Parameter:
<index> - message index.
The output depends on the last settings of command +CMGF
(message format to be used)
(PDU Mode)
If there is a message in location <index>, the output has the
following format:
+CMGR: <stat>,<alpha>,<length><CR><LF><pdu>
where