Rainbow Electronics GM862-QUAD-PY - Manual (Page 153)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 153 of 434
+CGEREP - GPRS Event Reporting SELINT 2
used to reactivate the context is provided if known to TA
+CGEV: NW DEACT <PDP_type>, <PDP_addr>, [<cid>]
The network has forced a context deactivation. The <cid> that was
used to activate the context is provided if known to TA
+CGEV: ME DEACT <PDP_type>, <PDP_addr>, [<cid>]
The mobile equipment has forced a context deactivation. The <cid>
that was used to activate the context is provided if known to TA
+CGEV: NW DETACH
The network has forced a GPRS detach. This implies that all active
contexts have been deactivated. These are not reported separately
+CGEV: ME DETACH
The mobile equipment has forced a GPRS detach. This implies that all
active contexts have been deactivated. These are not reported
separately
+CGEV: ME CLASS <class>
The mobile equipment has forced a change of MS class. The highest
available class is reported (see +CGCLASS)
AT+CGEREP? Read command returns the current <mode> and <bfr> settings, in the
format:
+CGEREP: <mode>,<bfr>
AT+CGEREP=? Test command reports the supported range of values for the +CGEREP
command parameters.
Reference GSM 07.07
3.5.4.7.4 GPRS Network Registration Status - +CGREG
+CGREG - GPRS Network Registration Status SELINT 0 / 1
AT+CGREG[=
[<n>]] Set command controls the presentation of an unsolicited result code
+CGREG: (see format below).
Parameter:
<n> - result code presentation mode
0 - disable network registration unsolicited result code
1 - enable network registration unsolicited result code; if there is a change
in the terminal GPRS network registration status, it is issued the
unsolicited result code:
+CGREG: <stat>
where: