Rainbow Electronics GM862-QUAD-PY - Manual (Page 41)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 41 of 434
Q - Quiet Result Codes SELINT 0 / 1
<n>
0 - enables result codes (factory default)
1 - every result code is replaced with a <CR>
2 - disables result codes
Note: After issuing either ATQ1 or ATQ2 every information text transmitted
in response to commands is not affected
Note: if parameter is omitted, the command has the same behaviour as
ATQ0
Example After issuing ATQ1
AT+CGACT=?
+CGACT: (0-1) a <cr> ends the response
After issuing ATQ2
AT+CGACT=?
+CGACT: (0-1) nothing is appended to the response
Reference V25ter
Q - Quiet Result Codes
SELINT 2
ATQ[<n>]
Set command enables or disables the result codes.
Parameter:
<n>
0 - enables result codes (factory default)
1 - disables result codes
2 - disables result codes (only for backward compatibility)
Note: After issuing either ATQ1 or ATQ2 every information text transmitted
in response to commands is not affected
Note: if parameter is omitted, the command has the same behaviour of
ATQ0
Example After issuing ATQ1 or ATQ2
AT+CGACT=?
+CGACT: (0-1) nothing is appended to the response
Reference V25ter
3.5.3.2.3 Response Format - V
V - Response Format SELINT 0 / 1 / 2
ATV[<n>]
Set command determines the contents of the header and trailer transmitted
with result codes and information responses. It also determines if result