Rainbow Electronics GM862-QUAD-PY - Manual (Page 79)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 79 of 434
+CNUM - Subscriber Number SELINT 2
previously enabled (see #ENS)
Execution command returns the MSISDN (if the phone number of the
device has been stored in the SIM card) in the format:
+CNUM: <alpha>,<number>,<type>
If the ENS functionality has been
previously enabled (see #ENS)
Execution command returns the MSISDN (if the phone number of the
device has been stored in the SIM card) in the format:
+CNUM: <alpha>,<number>,<type>[<CR><LF>
+CNUM: <alpha>,<number>,<type>[…]]
where:
<alpha> - alphanumeric string associated to <number>; used character set
should be the one selected with +CSCS.
<number> - string containing the phone number in the format <type>
<type> - type of number:
129 - national numbering scheme
145 - international numbering scheme (contains the character "+").
AT+CNUM=? Test command returns the OK result code
Reference GSM 07.07
3.5.4.3.2 Read Operator Names - +COPN
+COPN - Read Operator Names SELINT 0 / 1
AT+COPN Execution command returns the list of operator names from the ME in the
format:
+COPN: <numeric1>,<alpha1>[<CR><LF><CR><LF>
+COPN: <numeric2>,<alpha2>[…]]
where:
<numericn> - string type, operator in numeric format (see +COPS)
<alphan> - string type, operator in long alphanumeric format (see +COPS)
Note: each operator code <numericn> that has an alphanumeric equivalent
<alphan> in the ME memory is returned
Reference GSM 07.07
+COPN - Read Operator Names
SELINT 2