6 command line editing character - s5, 7 connection completion time-out - s7 – Rainbow Electronics GM862-QUAD-PY User Manual
Page 63
AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 63 of 434
3.5.3.7.6 Command Line Editing Character - S5
S5 - Command Line Editing Character
SELINT 0 / 1
ATS5[=<char>]
Set command sets the value of the character recognized by the device as a
request to delete from the command line the immediately preceding
character.
Parameter:
<char> - command line editing character (decimal ASCII)
0..127 - factory default value is 8 (ASCII BS).
ATS5?
Read command returns the current value of S5 parameter.
ATS5=?
Test command returns the range for <char> without command echo and
parenthesis.
Note
For either Read and Test command the format of the numbers in output is
always 3 digits, left-filled with 0s
Reference V25ter
S5 - Command Line Editing Character
SELINT 2
ATS5=[<char>]
Set command sets the value of the character recognized by the device as a
request to delete from the command line the immediately preceding
character.
Parameter:
<char> - command line editing character (decimal ASCII)
0..127 - factory default value is 8 (ASCII BS)
ATS5?
Read command returns the current value of S5 parameter.
Note: the format of the numbers in output is always 3 digits, left-filled with 0s
Reference V25ter
3.5.3.7.7 Connection Completion Time-Out - S7
S7 - Connection Completion Time-Out
SELINT 0 / 1
ATS7[=<tout>]
Set command sets the amount of time, in seconds, that the device shall
allow between either answering a call (automatically or by A command) or
completion of signalling of call addressing information to network (dialling),
and establishment of a connection with the remote device.
Parameter:
<tout> - number of seconds
1..255 - factory default value is 60.
ATS7?
Read command returns the current value of S7 parameter.
ATS7=?
Test command returns the range for <tout> without command echo and
parenthesis.
Note
For either Read and Test command the format of the numbers in output is
always 3 digits, left-filled with 0s
Reference V25ter