Rainbow Electronics GM862-QUAD-PY - Manual (Page 97)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 97 of 434
+CCFC - Call Forwarding Number And Condition SELINT 0 / 1 / 2
<number> - string type phone number of forwarding address in format
specified by <type> parameter
<type> - type of address octet in integer format :
129 - national numbering scheme
145 - international numbering scheme (contains the character "+")
<class> - sum of integers each representing a class of information which
the command refers to; default 7 (voice + data + fax)
1 - voice (telephony)
2 - data
4 - fax (facsimile services)
8 - short message service
16 - data circuit sync
32 - data circuit async
64 - dedicated packet access
128 - dedicated PAD access
<time> - time in seconds to wait before call is forwarded; it is valid only
when <reason> "no reply" is enabled (<cmd>=1) or queried
(<cmd>=2)
1..30 - automatically rounded to a multiple of 5 seconds (default is 20)
Note: when <cmd>=2 and command successful, it returns:
+CCFC: <status>,<class1>[,<number>,<type>[,,,<time>]][<CR><LF>
+CCFC: <status>,<class2>[,<number>,<type>[,,,<time>]][ … ]]
where:
<status> - current status of the network service
0 - not active
1 - active
<classn> - same as <class>
<time> - it is returned only when <reason>=2 (“no reply”) and <cmd>=2.
The other parameters are as seen before.
AT+CCFC=? Test command reports supported values for the parameter <reason>.
Reference GSM 07.07
Note When querying the status of a network service (<cmd>=2) the response line
for 'not active' case (<status>=0) should be returned only if service is not
active for any <class>.
3.5.4.3.11 Call Waiting - +CCWA
+CCWA - Call Waiting SELINT 0 / 1
AT+CCWA[=
[<n>[,<cmd>
[,<class>]]]] Set command allows the control of the call waiting supplementary service.
Activation, deactivation, and status query are supported.