Rainbow Electronics GM862-QUAD-PY - Manual (Page 334)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 334 of 434
#PASSW - Authentication Password SELINT 0/1
OK
#PASSW - Authentication Password
SELINT 2
AT#PASSW=
[<pwd>] Set command sets the user password string to be used during the
authentication step.
Parameter:
<pwd> - string type, it’s the authentication password; the max length for this
value is the output of Test command, AT#PASSW=? (factory
default is the empty string “”).
Note: this command is not allowed for sockets associated to a GSM context
(see #SCFG).
AT#PASSW=? Test command returns the maximum allowed length of the string parameter
<pwd>.
Example AT#PASSW="myPassword"
OK
3.5.7.5.3 Packet Size - #PKTSZ
#PKTSZ - Packet Size SELINT 0 / 1
AT#PKTSZ[=
[<size>]] Set command sets the default packet size to be used by the TCP/UDP/IP
stack for data sending.
Parameter:
<size> - packet size in bytes
0 - automatically chosen by the device
1..512 - packet size in bytes (factory default is 300)
Note: issuing AT#PKTSZ<CR> is the same as issuing the Read command.
Note: issuing AT#PKTSZ=<CR> is the same as issuing the command
AT#PKTSZ=0<CR>.
AT#PKTSZ? Read command reports the current packet size value.
Note: after issuing command AT#PKTSZ=0, the Read command reports the
value automatically chosen by the device.
AT#PKTSZ=? Test command returns the allowed values for the parameter <size>.
Example AT#PKTSZ=100
OK
AT#PKTSZ?
#PKTSZ: 100
OK
AT#PKTSZ=0
OK
AT#PKTSZ?