Rainbow Electronics GM862-QUAD-PY - Manual (Page 308)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 308 of 434
#GPPPCFG - PPP-GPRS Parameters Configuration SELINT 2
1 - active mode, the module starts autonomously the LCP negotiation
immediately after the CONNECT message
Note: if <hostIPaddress>=”0.0.0.0” (factory default) the Host IP Address
assigned to the host application is the previous remote IP Address
obtained by the Network.
AT# GPPPCFG? Read command reports the current PPP-GPRS connection parameters in
the format:
#GPPPCFG: <hostIPaddress>,<LCPtimeout>,<PPPmode>
AT# GPPPCFG=? Test command returns the range of supported values for parameter
<LCPtimeout> and <PPPmode>, in the format:
#PPPCFG: “”,(10-600),(0,1)
3.5.7.1.81 RTC Status - #RTCSTAT
#RTCSTAT - RTC Status SELINT 0 / 1
AT#RTCSTAT[=
<status>] Set command resets the RTC status flag.
Parameter:
<status>
0 - Set RTC Status to RTC HW OK
Note: the initial value of RTC status flag is RTC HW Error and it doesn’t
change until a command AT#RTCSTAT=0 is issued.
Note: if a power failure occurs and the buffer battery is down the RTC
status flag is set to 1. It doesn’t change until command AT#RTCSTAT=0 is
issued.
Note: if parameter <status> is omitted the behaviour of Set command is
the same as Read command.
AT#RTCSTAT? Read command reports the current value of RTC status flag, in the format:
#RTCSTAT: <status>
AT#RTCSTAT=? Test command returns the range of supported values for parameter
<status>
#RTCSTAT - RTC Status
SELINT 2