Rainbow Electronics GM862-QUAD-PY User Manual

Page 244

Advertising

AT Commands Reference Guide

80000ST10025a Rev. 5 - 09/07/08

page 244 of 434

#SRS - Select Ringer Sound

SELINT 0 / 1

Note: if command is issued with <n> = 0 and <tout> > 0 then the current
ringing tone is played.

Note: if both <n> and <tout> are 0 then the default ringing tone is set as
current and ringing is stopped.

Note: If all parameters are omitted then the behaviour of Set command is
the same as Read command

AT#SRS?

Read command reports current selected ringing and its status in the form:

#SRS: <n>,<status>

where:
<n> - ringing tone number
1..max
<status> - ringing status
0 - selected but not playing
1 - currently playing

AT#SRS=?

Test command reports the supported values for the parameters <n> and
<tout>

#SRS - Select Ringer Sound

SELINT 2

AT#SRS=
[<n>,<tout>]

Set command sets the ringer sound.

Parameters:
<n> - ringing tone
0 - current ringing tone
1..max - ringing tone number, where max can be read by issuing the Test

command AT#SRS=?.

<tout> - ringing tone playing timer in units of seconds.
0 - ringer is stopped (if present) and current ringer sound is set.
1..60 - ringer sound playing for <tout> seconds and, if <n> > 0, ringer

sound <n> is set as default ringer sound.

Note: when the command is issued with <n> > 0 and <tout> > 0, the <n>
ringing tone is played for <tout> seconds and stored as default ringing tone.

Note: if command is issued with <n> > 0 and <tout> = 0, the playing of the
ringing is stopped (if present) and <n> ringing tone is set as current.

Note: if command is issued with <n> = 0 and <tout> > 0 then the current
ringing tone is played for <tout> seconds.

Note: if both <n> and <tout> are 0 then the default ringing tone is set as
current and ringing is stopped.

Advertising