Rainbow Electronics GM862-QUAD-PY - Manual (Page 250)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 250 of 434
3.5.7.1.18 PLMN List Selection - #PLMNMODE
#PLMNMODE - PLMN List Selection SELINT 0 / 1 / 2
AT#PLMNMODE=
[<plmnlist>] Set command selects the list of PLMN names to be used currently
Parameter:
<plmnlist> - list of PLMN names
0 - PLMN names list, currently used in commands like +COPS or #MONI,
is fixed and depends upon currently selected interface (see #SELINT)
(default)
1 - PLMN names list is not fixed and can be updated in newer software
versions
Note: <plmnlist> parameter is saved in NVM
AT#PLMNMODE? Read command reports whether the currently used list of PLMN names is
fixed or not, in the format:
#PLMNMODE: <plmnlist>
(<plmnlist> described above)
AT#PLMNMODE=? Test command returns the supported range of values for parameter
<plmnlist>.
3.5.7.1.19 Display PIN Counter - #PCT
#PCT - Display PIN Counter SELINT 0 / 1
AT#PCT Execution command reports the PIN/PUK or PIN2/PUK2 input remaining
attempts, depending on +CPIN requested password in the format:
#PCT: <n>
where:
<n> - remaining attempts
0 - the SIM is blocked.
1..3 - if the device is waiting either SIM PIN or SIM PIN2 to be given.
1..10 - if the device is waiting either SIM PUK or SIM PUK2 to be given.
AT#PCT? Read command has the same behaviour as Execution command.
#PCT - Display PIN Counter
SELINT 2
AT#PCT Execution command reports the PIN/PUK or PIN2/PUK2 input remaining
attempts, depending on +CPIN requested password in the format:
#PCT: <n>
where:
<n> - remaining attempts
0 - the SIM is blocked.
1..3 - if the device is waiting either SIM PIN or SIM PIN2 to be given.
1..10 - if the device is waiting either SIM PUK or SIM PUK2 to be given.
AT#PCT=? Test command returns the OK result code.